LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Seat System) >> Repair Instructions >> Seat Back Recliner Replacement - Front (AF5) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the recliner to the seat.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the recliner bolts (1,2).

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

    Fig 1: Installing Seat Recliner Bolts - Front (AF5)
    GM279088Courtesy of GENERAL MOTORS CORP.
  3. Install the seat back pad and cover to a desired appearance.
  4. Install the EZ entry adjuster cable (4) to the seat adjuster (3).
  5. Install the EZ entry adjuster cable (4) to the adjuster cable bracket (5).
  6. Fasten the J-hook retainer located next to SIAB module, if equipped.
  7. Fasten the J-hook retainer located at the bottom of the seat back cover.
  8. At the bottom of the seat back (1) install the lateral release knob to the recliner. Press the lateral release knob till fully seated on the recliner.
    Fig 2: Installing EZ Entry Adjuster Cable - Front (AF5)
    GM901685Courtesy of GENERAL MOTORS CORP.
  9. Install the outer trim panel on the seat cushion. Refer to Seat Cushion Outer Trim Panel Replacement .
  10. Install the front bucket seat. Refer to Seat Replacement - Passenger Front EZ Entry .
  11. Reposition the seat back (1) to the original position.
  12. Check seat back recliner for proper operation.
  13. Enable the SIR system, if equipped with SIAB. Refer to SIR Disabling and Enabling Zone 7 or to SIR Disabling and Enabling Zone 9 in SIR.
scientia non olet · About LEMON Manuals