LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Seat System) >> Repair Instructions >> Seat Back Frame Replacement - Front (With AJ7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling Zones. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 7 , or SIR Disabling and Enabling Zone 9 in SIR.
  2. Remove the front bucket seat. Refer to Seat Replacement .
  3. Remove the seat back cover and pad. Refer to Seat Back Cover Replacement - Front (With AJ7)  or Seat Back Cover Replacement - Front (Without AJ7) .
  4. Remove the head restraint guides (6) from the seat back frame (7).
  5. Unfasten the wire harness for the inflatable restraint module.
  6. Remove the recliner bolts (9).
  7. Remove the pivot bolt (13).
  8. Remove the seat back frame (7) from the recliner (11).
    Fig 1: Removing Head Restraint Guides (With AJ7)
    GM873909Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals