LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Seat System) >> Repair Instructions >> Seat Back Frame Replacement - Front (With AJ7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat back frame (7) to the recliner (11).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the recliner bolts (9).

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  3. Install the pivot bolt (13).

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  4. Fasten the wire harness for the inflatable restraint module.
  5. Install the head restraint guides (6) from the seat back frame (7).
    Fig 1: Installing Seat Recliner Bolts (With AJ7)
    GM873909Courtesy of GENERAL MOTORS CORP.
  6. Install the seat back cover and pad. Refer to Seat Back Cover Replacement - Front (With AJ7)  or Seat Back Cover Replacement - Front (Without AJ7) .
  7. Install the front bucket seat. Refer to Seat Replacement .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 , or SIR Disabling and Enabling Zone 9 in SIR.
scientia non olet · About LEMON Manuals