LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad - Rear Split Folding >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat back cover assembly to the seat back frame (2).
  2. Fold the bottom and sides of the cover over the seat back frame (2).
  3. Install the stables to the bottom and sides of the cover.
  4. Fold the back side of the cover (1) over the seat back frame (2).
  5. Use firm hand pressure in order to fasten the hook and the loop retainer on the back side of the cover (1).
    Fig 1: Installing Seat Back Cover - Rear Split Folding
    GM875661Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  6. Install the pivot bolt (3) to the frame (2).

    Tighten:  Tighten the pivot bolt to 6 N.m (53 lb in).

  7. Install the split/folding rear seat back. Refer to Seat Back Replacement - Rear Split Folding .
scientia non olet · About LEMON Manuals