LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Seat System) >> Repair Instructions >> Lumbar Actuator Replacement - Manual >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cable end (2) to the actuator (1). Rotate the cable end (2) 90 degrees downward.
  2. Install the cable conduit (3) to the retainer on the actuator (1). Press the cable conduit (3) into retainer on the actuator (1) until fully engaged.
  3. Install the actuator (1) to the seat cushion frame.
    Fig 1: Installing Lumbar Actuator Cable - Manual
    GM834271Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Through the opening in the seat cushion cover, install the actuator screws.

    Tighten:  Tighten the screw to 1.2 N.m (10 lb in).

  5. Align the actuator knob to the splines on the actuator (1). Press the actuator knob until fully engaged on the actuator (1).
scientia non olet · About LEMON Manuals