Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Fig 1: Identifying Compartment Lid

Courtesy of GENERAL MOTORS CORP.

Prop the compartment lid (2) in the full-open position.
Use the J 39719 , J 39384-10 or the equivalent (6) in order to remove the torque rod (5) from the adjusting notch. See Special Tools and Equipment .

Fig 2: Aligning Torque Rod
Courtesy of GENERAL MOTORS CORP.
With the torque rod removed from the adjuster notch, push the rod out of the hinge arm.
Remove the torque rod (1) from the rear compartment lid hinge (4).

Fig 3: Removing Torque Rod
Courtesy of GENERAL MOTORS CORP.