Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Position the spoiler on the rear compartment lid.
- Push firmly on the outboard edges of the spoiler to seat the spoiler into the grommets on the rear compartment lid.
- Pull gently on the wire harness of the spoiler in order to seat the grommet.
- Connect the wire harness connector (1) to the spoiler.
- Install the spoiler nut.
Tighten: Tighten the nut to 5 N.m (44 lb in).
- Install the spoiler bolts (4).
Tighten: Tighten the bolts to 5 N.m (44 lb in).
NOTE:
Refer to Fastener Notice
in Cautions and Notices.