Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Position the lock striker (1) to the alignment marks.
- Install the lock striker reinforcement plate (2).
- Install and hand tighten the striker nuts (3).
- Slowly close the compartment lid and check the striker alignment.
- Tighten the lock striker nuts (3).
Tighten: Tighten the rear compartment lid lock striker nuts to 10 N.m (89 lb in).
NOTE:
Refer to Fastener Notice
in Cautions and Notices.