Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Position the latch assembly (3) to the alignment marks.
- Install the latch assembly bolts (7).
Tighten: Tighten the rear compartment lid latch assembly bolts to 6 N.m (53 lb in).
- Install the remote release cable (1) to the lock release box, if equipped.
- Clip the cable door at the top of the lock release box (2), if equipped.
- Install the lock cable assembly (8).
NOTE:
Refer to Fastener Notice
in Cautions and Notices.