Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Install the striker (3) to the I/P carrier (1).
Install the screws (2) to the striker (3).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: Identifying (I/P) Compartment Striker Screws

Courtesy of GENERAL MOTORS CORP.

Adjust the striker (3) for proper alignment to the I/P compartment.
Tighten: Tighten the screws to 2.3 N.m (20 lb in).
Install the I/P trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) (Chevrolet) or Trim Pad Replacement - Instrument Panel (I/P) (Pontiac) .