LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Shaft, Lower Bearing, and Jacket Replacement (Standard) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the support mounting bracket (2).
  2. Lubricate the new support screws (1) with LOCTITE® 242, GM P/N 123455382 (Canadian P/N 10953489).
    Fig 1: Lubricate Support Mounting Adapter Screws
    GM599105Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install 4 new support screws (1).

    Tighten:  Tighten the screws to 8 N.m (71 lb in).

  4. Install the steering shaft assembly (2) into the steering column jacket assembly.
    Fig 2: View Of Steering Shaft & Lower Bearing
    GM372193Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The bearing retainer must be seated correctly on the steering shaft.
  5. Install the new bearing retainer (1).
  6. Install the adapter and bearing assembly (3).
  7. Install the lower bearing seat (4).
    IMPORTANT: When installing, compress the lower bearing spring (5) to the length of 23.5 mm (0.93 inches) between the lower bearing seat (4) and the lower spring retainer (6).
  8. Install the lower bearing spring (5).
  9. Install the new lower spring retainer (6).
    CAUTION: Refer to SIR INFLATOR MODULE COIL CAUTION in Cautions and Notices.
  10. Install the steering column jacket. Refer to Steering Column Jacket Replacement .
  11. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals