Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Install the inner race (5).
Install the upper bearing inner race seat (4).
Install the upper bearing spring (3).
Lubricate the turn signal cancel cam assembly (2) with GM P/N 12377900 (Canadian P/N 10953529).

Fig 1: Lubricating Turn Signal Cancel Cam Assembly
Courtesy of GENERAL MOTORS CORP.
Install the turn signal cancel cam assembly (2).
Install the shaft lock (1).
Install the new bearing retainer using J 23653-SIR and J 42137 .

Fig 2: Compressing Cam Orientation Plate Using J 23653-SIR & J 42137
Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to SIR INFLATOR MODULE COIL CAUTION in Cautions and Notices.
Install the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement (Coil) in SIR.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.