LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (Steering Wheel & Steering Column) >> Repair Instructions >> Multifunction, Turn Signal Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connectors to the multifunction switch (2).
  2. Install the multifunction switch (2) to the steering column while depressing the spring loaded horn pin.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the retaining screws to the multifunction switch (2).

    Tighten:  Tighten the screws to 4 N.m (36 lb in).

    Fig 1: Exploded View Of Multifunction, Tilt Lever & Turn Signal Switch
    GM307332Courtesy of GENERAL MOTORS CORP.
  4. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  5. Connect the negative battery cable.
  6. Ensure that the multifunction switch functions properly.
scientia non olet · About LEMON Manuals