LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (Steering Wheel & Steering Column) >> Repair Instructions >> Ignition Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ignition switch assembly (3) to the steering column (1).
    Fig 1: View Of Ignition Switch Assembly
    GM600922Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the retaining screws (2) to the ignition switch assembly (3).

    Tighten:  Tighten the screws to 4 N.m (36 lb in).

  3. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement (Without Key)  or Ignition Lock Cylinder Replacement (With Key) .
  4. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  5. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals