LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (Steering Wheel & Steering Column) >> Repair Instructions >> Ignition Lock Cylinder Replacement (Without Key) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Ensure that all the metal shavings are cleaned from the steering column and ignition housing assembly.
  1. Connect the electrical connector (3) to the ignition lock cylinder (1).
    Fig 1: View Of Ignition Lock Cylinder
    GM491353Courtesy of GENERAL MOTORS CORP.
  2. Insert the ignition lock cylinder (1) into the housing assembly while rotating the key approximately 5 degrees counter - clockwise.
  3. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  4. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  5. Connect the negative battery cable.
  6. Perform the Passlock Learn Procedure. Refer to Programming Theft Deterrent System Components in Theft Deterrent.
scientia non olet · About LEMON Manuals