LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Controls - 2.2L (L61) Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine/Chassis >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the chassis purge pipe from the engine purge pipe.
  2. Plug the engine purge pipe and chassis purge pipe to prevent contamination.
  3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Disconnect the chassis purge pipe from the canister purge pipe.
  5. Plug the canister purge pipe and chassis purge pipe to prevent contamination.
  6. Remove the exhaust heat shield.
  7. Remove the fuel bundle mounting bolts from the body clips.
    Fig 1: View Of Fuel Pipe Mounting Bolts
    GM102056Courtesy of GENERAL MOTORS CORP.
  8. Remove the chassis purge pipe from the body clips.
    Fig 2: Viewing Fuel Pipes In Body Clips
    GM102255Courtesy of GENERAL MOTORS CORP.
  9. Remove the chassis purge pipe (1) to be serviced.
    Fig 3: View Of Fuel Hose/Pipe & Retainers At Vehicle Underbody
    GM49888Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals