LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Controls - 2.2L (L61) Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the EVAP canister vent valve harness connector.
    Fig 1: View Of EVAP Canister Vent Valve Harness Connector
    GM409025Courtesy of GENERAL MOTORS CORP.
  2. Install the clip into the EVAP canister vent valve harness connector.
    Fig 2: Identifying EVAP Canister Vent Valve Harness Connector Clip
    GM409023Courtesy of GENERAL MOTORS CORP.
  3. Install the EVAP canister vent valve by pushing the mounts into the original holes.
    Fig 3: Rotating EVAP Canister Vent Valve
    GM625834Courtesy of GENERAL MOTORS CORP.
  4. Lubricate the hose end with lubricant.
  5. Install the hose to the EVAP canister vent valve.
    Fig 4: View Of EVAP Canister Vent Valve Hose
    GM625819Courtesy of GENERAL MOTORS CORP.
  6. Slide the EVAP canister vent valve hose clamp down on to the hose connection at the EVAP canister vent valve.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals