LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Controls - 2.2L (L61) Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the hoses from the evaporative emissions (EVAP) canister.
    Fig 1: View Of Evaporative Emissions (EVAP) Canister Hoses
    GM102404Courtesy of GENERAL MOTORS CORP.
  3. Remove the attaching bolt from the EVAP canister retainer.
    Fig 2: Identifying EVAP Canister Retainer Bolt
    GM102405Courtesy of GENERAL MOTORS CORP.
  4. Remove the EVAP canister and the retainer.
    Fig 3: Supporting EVAP Canister & Retainer
    GM102409Courtesy of GENERAL MOTORS CORP.
    NOTE: The EVAP canister may have released carbon particles which caused this part to fail and may cause damage to other components. Check the EVAP canister for loose carbon before returning the vehicle to service.
  5. Remove the EVAP canister retainer from the canister.
    Fig 4: View Of EVAP Canister Retainer
    GM102414Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals