LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Controls - 2.2L (L61) Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Snap the EVAP canister retainer onto the EVAP canister.
    Fig 1: View Of EVAP Canister Retainer
    GM102414Courtesy of GENERAL MOTORS CORP.
  2. Install the end of the EVAP canister into the tab on the body.
    Fig 2: Supporting EVAP Canister & Retainer
    GM102409Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the attaching bolt to the EVAP canister retainer.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    Fig 3: Identifying EVAP Canister Retainer Bolt
    GM102405Courtesy of GENERAL MOTORS CORP.
  4. Reconnect the hoses to the EVAP canister.
    Fig 4: View Of Evaporative Emissions (EVAP) Canister Hoses
    GM102404Courtesy of GENERAL MOTORS CORP.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals