LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Controls - 2.2L (L61) Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the EVAP canister purge valve on to the purge bracket.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the EVAP canister purge valve and bracket.

    Tighten:  Tighten the purge bracket nut to 8 N.m (71 lb in).

    Fig 1: View Of EVAP Canister Purge Valve & Bracket
    GM783170Courtesy of GENERAL MOTORS CORP.
  3. Connect the purge pipe to the EVAP canister purge valve.
  4. Connect the vacuum pipe to the EVAP canister purge valve.
  5. Connect the EVAP canister purge valve harness connector.
scientia non olet · About LEMON Manuals