LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Controls - 2.2L (L61) Introduction) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the front air deflector, if applicable.
  4. Remove the starter. Refer to Starter Motor Replacement in Engine Electrical.
  5. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
  6. Remove the CKP sensor bolt.
  7. Remove the CKP sensor.
    Fig 1: View Of Crankshaft Position (CKP) Sensor
    GM770823Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals