Enabling Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the key from the ignition switch.
- Connect the SIS-LH connector (4).
- Install the CPA (3) to the SIS-LH connector (4).
- Install the SIS-LH (1) to the LH door (4). Refer to Inflatable Restraint Side Impact Sensor Replacement (Sedan) or Inflatable Restraint Side Impact Sensor Replacement (Coupe) .
- Install the LH door trim panel (2). Refer to Trim Panel Replacement - Side Front Door (Pontiac) or Trim Panel Replacement - Side Front Door (Chevrolet) in Doors.
- Install the AIR BAG fuse to the LH I/P wiring harness junction block.
- Install the LH I/P outer trim cover. Refer to Instrument Panel (I/P) Outer Trim Cover Replacement (Chevrolet) or Instrument Panel (I/P) Outer Trim Cover Replacement (Pontiac) in Instrument Panel, Gages, and Console.
- Staying well away from both air bags, turn ON the ignition.
- The AIR BAG indicator will flash 7 times.
- The AIR BAG indicator will then turn OFF.
- Perform Diagnostic System Check - SIR if the AIR BAG indicator does not operate as described.