Side Inflator Module Deployment - Component Replacement and Inspections
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
After a collision involving a side inflator module deployment, replace the following components on the side of the impact.
- Inflatable restraint sensing and diagnostic module (SDM)
- Inflatable restraint side impact sensor (SIS)
- Inflatable restraint side impact module
Perform additional inspections on the following components.
- Mounting points or mounting hardware for the inflatable restraint SIS and side impact module on the side of the impact - Inspect for any damage and repair or replace each component as needed.
- Mounting points or mounting hardware for the inflatable restraint SDM - Inspect for any damage and repair or replace each component as needed.