LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Sensor Replacement (Sedan) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the side impact sensor connector (4).
    Fig 1: Identifying Side Impact Sensor (SIS) Connector
    GM834331Courtesy of GENERAL MOTORS CORP.
  2. Install the CPA (3) to the side impact sensor connector (4).
  3. Remove any dirt, grease, or other impurities from the mounting surface.
  4. Install the side impact sensor to the center pillar (1).
    Fig 2: Locating Inflatable Restraint Side Impact Sensor (SIS)
    GM834329Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Align the locating pin on the sensor to the opening in the center pillar (1).

    Begin tightening the side impact sensor bolts (2).

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

  6. Install the center pillar upper trim. Refer to Trim Panel Replacement - Upper Center Pillar in Interior Trim.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9 , or SIR Disabling and Enabling Zone 7 .
scientia non olet · About LEMON Manuals