LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Sensor Replacement (Coupe) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove any dirt, grease, or other impurities from the mounting surface.
  2. Connect the side impact sensor connector (4).
    Fig 1: Identifying Side Impact Sensor (SIS) Connector
    GM834331Courtesy of GENERAL MOTORS CORP.
  3. Install the CPA (3) to the side impact sensor connector (4).
  4. Install the side impact sensor (1) to the door (4).
    Fig 2: View Of Inflatable Restraint Side Impact Sensor (SIS)
    GM863414Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Align the locating pin on the sensor (1) to the opening in the door (4).

    Begin tightening the side impact sensor bolts (2).

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

  6. Install the water deflector to the door.
  7. Install the door trim panel. Refer to Trim Panel Replacement - Side Front Door (Pontiac) or Trim Panel Replacement - Side Front Door (Chevrolet) in Doors.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9 , or SIR Disabling and Enabling Zone 7 .
scientia non olet · About LEMON Manuals