Removal & Installation: Accumulator: Installation
WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Install the accumulator. Install the accumulator bracket clamp. Tighten the bolt to specification. Install NEW O-ring seals to refrigerant lines. Install the refrigerant lines to the accumulator. Install the accumulator tube to accumulator and compressor tube to accumulator fitting nuts.
- Position the bracket holding the PCM module on to the shock tower. Install the bracket nuts holding the PCM module on to the shock tower and tighten. Reposition the cruise control bracket if equipped. Evacuate and recharge the A/C system. See RECOVERY, EVACUATION & RECHARGING in GENERAL SERVICING PROCEDURES article in GENERAL SERVICING.