Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to ELECTRICAL WIRING ROUTING NOTICE in Cautions and Notices.

Position the tail lamp to the quarter panel.
Align the tail lamp to the rear compartment lid applique.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the nuts (2) to the tail lamp.
Tighten: Tighten the tail lamps nuts to 6 N.m (53 lb in).

Fig 1: Installing Tail Lamp Nuts (Pontiac)
Courtesy of GENERAL MOTORS CORP.
Install the bulb to the socket, if required.
Install the bulb/socket (3) to the tail lamp.
Connect the electrical connector to the tail lamp (3).