Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to ELECTRICAL WIRING ROUTING NOTICE in Cautions and Notices.

Install the tail lamp to the quarter panel.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the tail lamp nuts (2) to the tail lamp.
Tighten: Tighten the tail lamp nuts (2) to 5 N.m (44 lb in).

Fig 1: Installing Tail Lamp Nuts (Chevrolet)
Courtesy of GENERAL MOTORS CORP.
Connect the electrical connector (1) to the tail lamp.
Install the bulb to the socket, if required.
Install the bulb/socket to the tail lamp.
Pull back the rear compartment trim. Refer to Compartment Trim Panel Replacement - Rear in Body Rear End.