LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 204 (Lighting Systems) >> Repair Instructions >> License Lamp Replacement (Sedan and Coupe) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bulb to the socket.
  2. Install the socket to the license plate lamp by turning the socket clockwise.
  3. Install the license plate lamp (1) to the rear bumper fascia.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the screws (3) to the license plate lamp.

    Tighten:  Tighten the license plate lamp screws to 2 N.m (18 lb in).

    Fig 1: Installing License Plate Lamp Screws (Sedan and Coupe)
    GM276667Courtesy of GENERAL MOTORS CORP.
  5. Install the license plate to the rear bumper fascia.
scientia non olet · About LEMON Manuals