LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 204 (Lighting Systems) >> Repair Instructions >> Door Jamb Switch Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When a new jamb switch is installed and the door is closed the first time, the plunger is forced into the sleeve and automatically adjusts the jamb switch for that particular door. If a jamb switch fails, do not readjust the switch. Install a new jamb switch.
  1. Position the door jamb switch by the pillar.
  2. Connect the door jamb switch electrical connector.
    Fig 1: Connecting Front Door Jamb Switch Electrical Connector
    GM384957Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the door jamb switch (2).

    Tighten:  Tighten the door jamb switch to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals