Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Position the backup lamp to the rear bumper fascia.
NOTE: Refer to Fastener Notice in Cautions and Notices.
- Install the nuts to the backup lamp.
Tighten: Tighten the backup lamp nuts to 2 N.m (18 lb in).
- Install the bulb to the socket, if required.
- Install the bulb/socket to the backup lamp.
- Lower the vehicle.