High Beam Indicator Inoperative

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Step	Action	Yes	No
Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics
1	Did you perform the Lighting System Diagnostic System Check?	Go to Step 2	Go to Diagnostic System Check - Lighting Systems
2	Turn ON the ignition, with the engine OFF. Observe the high beam indicator on the instrument cluster. Does the indicator illuminate during the bulb check?	Go to Step 3	Go to Step 4
3	Place the headlamp switch in the HEADLAMP position. Place the headlamp dimmer switch in the HIGH position. Does the indicator illuminate?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 5
4	Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 8	Go to Step 6
5	Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 8	Go to Step 7
6	Replace the IPC. Refer to Instrument Panel Cluster (IPC) Replacement (Chevrolet) or Instrument Panel Cluster (IPC) Replacement (Pontiac) in Instrument Panel, Gages and Console. Did you complete the replacement?	Go to Step 8	-
7	IMPORTANT: Perform the set up procedure for the body control module. Replace the BCM. Refer to Body Control Module Replacement in Body Control Systems.Did you complete the replacement?	Go to Step 8	-
8	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2