Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Install the starter.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the starter bolts.
Tighten: Tighten the starter bolts to 40 N.m (30 lb ft).
- Connect the electrical connectors (4) to the starter.
Tighten: Tighten the battery terminal nut to 17 N.m (13 lb ft).
- Connect the electrical connectors (3) to the starter.
Tighten: Tighten the S terminal nut to 3 N.m (27 lb in).
- Lower the vehicle.
- Connect the negative battery cable.