LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (Power Steering System) >> Repair Instructions >> Power Steering Pressure Pipe/Hose Replacement (2.2L (LN2)) >> Power Steering System

Power Steering System

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation easier. Failure to follow these procedures could result in component damage.
  1. Install the power steering pressure hose (1) to the vehicle.
  2. Install the power steering hose retainer (2).
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the power steering pressure hose (1) to the power steering gear (3). Refer to Figure.

    Tighten the fitting to 27 N.m (20 lb ft).

  4. Install the front exhaust pipe, if removed. Refer to INTERMEDIATE PIPE REPLACEMENT (2.2L) or INTERMEDIATE PIPE REPLACEMENT (2.4L) .
  5. Lower the vehicle.
  6. Install the power steering pressure hose (2) to the power steering pump (1). Refer to Figure

    Tighten the fitting to 27 N.m (20 lb ft).

  7. Bleed the power steering system. Refer to Bleeding the Power Steering System .
scientia non olet · About LEMON Manuals