LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (Engine Mechanical - 2.2L (L61) (On-Vehicle)) >> Repair Instructions >> Intake Manifold Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. If removed, install the intake manifold gasket.
  2. Install the intake manifold.
  3. Install the intake manifold nuts and bolts. Tighten the intake manifold nuts and bolts to 10 N.m (89 lb in).
  4. Install the knock sensor connector to the intake manifold.
  5. Install the fuel rail.
  6. Install the throttle body.
  7. Connect the IAC electrical connector.
  8. Connect the TPS electrical connector.
  9. Connect the MAP sensor electrical connector.
  10. Connect the EVAP hose.
  11. Connect the PCV hose.
  12. Connect the purge solenoid tube.
  13. Connect the brake booster hose.
  14. Install the oil level indicator tube bolt.
  15. Connect the accelerator and the cruise control cables.
  16. Install the air inlet duct and resonator.
scientia non olet · About LEMON Manuals