LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Wiring Systems (General Information)) >> Diagnostic Information & Procedures >> Push To Seat Connectors >> Terminal Repair

Terminal Repair

WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Slip the cable seal away from the terminal.
  2. Cut the wire as close to the terminal as possible.
  3. Slip a new cable seal onto the wire.
  4. Strip 5 mm (3/16 in) of insulation from the wire.
  5. Crimp a new terminal to the wire.
  6. Solder the crimp with rosin core solder.
  7. Slide the cable seal toward the terminal.
  8. Crimp the cable seal and the insulation.
  9. If the connector is outside of the passenger compartment, apply grease to the connector.
scientia non olet · About LEMON Manuals