Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Install the shock absorber (5) to the vehicle.NOTE: See Fastener Notice . See Figure.
- Install the shock absorber lower mounting bolt (4).
Tighten
Tighten the bolt to 70 N.m (51 ft lbs).
- Raise the rear axle with a jackstand until the shock absorber (5) is in position to install the upper mounting bolts (2).
- Install the shock absorber upper mounting bolts (2).
Tighten
Tighten the bolts to 25 N.m (18 ft lbs).
- Remove the jackstand and lower the vehicle.
- Install the shock absorber upper mounting nut (1).
Tighten
Tighten the nut to 25 N.m (18 ft lbs).
- Install the tire and wheel.
- Replace the rear compartment carpet to the original position.