Ride Diagnosis - Too Hard
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Did you review the General Description and perform the necessary inspections? If so, go to next step. If not, go to SYMPTOMS - SUSPENSION GENERAL DIAGNOSIS .
- Verify that the ride is too hard. Does the vehicle ride normally? If so, then system is okay. If not, go to next step.
- Inspect the tires for the proper inflation pressure. Is the tire inflation pressure correct? If so, go to step 5. If not, go to next step.
- Inflate the tires to the correct pressure. Did you complete the repair? If so, go to next step.
- Inspect the springs and struts for wear or damage. Refer to STRUTS OR SHOCK ABSORBERS ON-VEHICLE TESTING . Are any of the components the worn or damaged? If so, go to next step. If not, go to step 7.
- Replace all of the worn or damaged components. For any strut component replacement, refer to STRUT, STRUT COMPONENT AND/OR SPRING or SHOCK ABSORBER REPLACEMENT . After repair is complete, go to next step.
- Operate the system in order to verify the repair. Did you correct the condition? If so, then system is okay. If not, go to step 3.