Shock Absorber Replacement: Installation
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Install the shock absorber (5) to the vehicle. See Figure. Install the shock absorber lower mounting bolt (4). Tighten the bolt to 70 N.m (51 lb ft).
- Raise the rear axle with a jackstand until the shock absorber (5) is in position to install the upper mounting bolts (2). See Figure. Install the shock absorber upper mounting bolts (2). Tighten the bolts to 25 N.m (18 lb ft).
- Remove the jackstand and lower the vehicle. Install the shock absorber upper mounting nut (1). Tighten the nut to 25 N.m (18 lb ft).
- Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in TIRES AND WHEELS. Replace the rear compartment carpet to the original position.