Axle Shaft Outer Joint & Boot: Notes

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Required Tools: CV Puller (J-41398), Slide Hammer (J-2619-01), Drive Axle Boot Clamp Pliers (J-35910) and Snap Ring Pliers (J-8039-A).

NOTE: Due to the helical splines on the axle shaft bar, disassembly and assembly of the joints will be difficult. Follow the instructions provided.