LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Disc Brake Hardware >> Installation

Disc Brake Hardware: Installation

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a thin layer of high temperature silicone brake lubricant to the exterior of the NEW brake caliper bushings. See Figure .
  2. Install the NEW bushings into the caliper assembly. Ensure that the chamfered end of the bushings are positioned outboard when in-vehicle. See Figure .
  3. Apply a liberal amount of high temperature silicone brake lubricant to the interior of the NEW bushings. Ensure that the lubricant fills the cavities beside the ribs on the inside of the bushings.
  4. Apply a thin layer of high temperature silicone brake lubricant to the bushing surface of the caliper bolts.
  5. Install the caliper bolts to the bushings. Thoroughly clean the brake pad mating surface on the steering knuckle of any surface debris and/or corrosion.
  6. Apply a thin layer of high temperature silicone brake lubricant to the brake pad mating surface on the steering knuckle.
  7. Install the disc brake pads. See BRAKE PADS  .
scientia non olet · About LEMON Manuals