LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Pedal Assembly >> Removal

Brake Pedal Assembly: Removal

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the accelerator cable from the accelerator pedal. See appropriate ENGINE MECHANICAL article in ENGINE.
  2. Remove the retaining clip and outer washer from the brake pedal. Disconnect the brake booster pushrod from the brake pedal.
  3. Remove the inner washer from the brake pedal. Remove the stop light switch from the brake pedal assembly. See STOPLIGHT SWITCH  .
  4. Remove the cruise control release switch, if equipped, from the brake pedal assembly.
  5. Release the electrical harness from the brake pedal assembly.
  6. Remove the brake booster mounting nuts.
  7. Remove the brake pedal assembly upper mounting nut.
  8. Remove the brake pedal assembly from the vehicle.
scientia non olet · About LEMON Manuals