LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Disc Brakes & Drum Brakes) >> Adjustments & Inspections >> Rear Brake Shoes

Rear Brake Shoes

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Required Tools: Brake/Drum Shoe Clearance Gauge (J-21177-A).
  1. Release the tension from the park brake cable system.
  2. Raise and support the vehicle.
  3. Remove the rear tire and wheel assemblies.
  4. Remove the brake drums.
  5. Position the J-21177-A to widest point of the brake drum inside diameter.
  6. Firmly hand tighten the set screw on the J-21177-A.
  7. Remove the J-21177-A from the brake drum and position it over the corresponding brake shoe assembly at its widest point.
  8. While holding the J-21177-A in position, insert a 0.635 mm (0.025 in) feeler gage between one side of the J-21177-A, and the corresponding brake shoe.
  9. Rotate the brake shoe adjuster screw until the brake shoes contact the J-21177-A, and the feeler gage. Brake shoe-to-drum clearance should be: 0.025 in (0.635 mm).
  10. Repeat the above steps for the opposite brake drum and brake shoe assembly.
  11. Install the brake drums.
  12. Restore the tension to the park brake cable system.
  13. Adjust the park brake.
  14. Install the rear tire and wheel assemblies. Tighten wheel lug nuts to specification. See TORQUE SPECIFICATIONS  .
  15. Lower the vehicle.
scientia non olet · About LEMON Manuals