Diagnostic Aids

WARNING: This page is about a different variant/trim than selected.

IMPORTANT:

Remove any debris from the PCM connector surfaces before servicing the PCM. Inspect the PCM connector gaskets when diagnosing/replacing the PCM. Ensure that the gaskets are installed correctly. The gaskets prevent contaminate intrusion into the PCM.
For any test that requires probing the PCM or a component harness connector, use the J 35616-A connector test adapter kit. Using this kit prevents damage to the harness/component terminals. Refer to SYSTEM WIRING DIAGRAMS .

For an intermittent condition, refer to SYMPTOMS - MANUAL TRANSMISSION .