Code Enable Criteria

WARNING: This page is about a different variant/trim than selected.

For DTC to run, the following conditions must be met:

DTC P0107, P0108, P0112, P0113, P0117, P0118, P0121, P0122, P0123, P0125, P0443, P0449, P0452, P0453, P1111, P1112, P1114, P1115, P1121, and P1122 are not set.
System voltage is 10-18 volts.
Start-up Engine Coolant Temperature (ECT) is 39-86°F (4-30°C).
Start-up Intake Air Temperature (IAT) is and 39-86°F (4-30°C).
ECT and IAT are within 16°F (9°C) of each other.
Fuel tank level is 15-85 percent.
BARO pressure more than 75 kPa.
Vehicle speed is less than 75 MPH.

DTC will set when EVAP system is not able to achieve or maintain vacuum during the diagnostic test.