Code Enable Criteria

WARNING: This page is about a different variant/trim than selected.

For DTC to run, the following conditions must be met:

DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0121, P0122, P0123, P0200, P0300, P0410, P0440, P0442, P0446, P0452, P0453, P1258, P1415, P1416, or P1441 are not set.
Ignition 1 signal is 9-18 volts.
Secondary Air Injection (AIR) and the catalyst diagnostics are not active.
Engine is in closed loop.
Engine run time is more than 409 seconds.

DTC will set when HO2S signal voltage remains between 350-550 mV for 57 seconds.