LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical 5.7L V8) >> Removal & Installation >> Oil Pan >> Removal

Oil Pan: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect negative battery cable. Support engine using the following equipment:
    • Engine Support Adapter (J-41044)
    • Engine Support Adapter Kit (J-42451)
    • Engine Support Adapter Leg (J-36462-A)
    • Universal Support Fixture (J-28467-B)

    Raise and support vehicle. Drain crankcase. Remove oil filter. Remove all engine mount-to-cradle bolts. Remove all lower shock bolts. Remove intermediate steering shaft bolt.

  2. Support the engine cradle using Engine Support Table (J-39580) and Table Top (J-39580-500), or equivalent. Disconnect oil level sensor connector. Remove oil level sensor. Remove starter. Remove left and right flywheel covers. Loosen 6 cradle bolts. Remove oil pan bolts and oil pan. Lower cradle to obtain clearance for oil pan removal. If additional clearance is needed, it may be necessary to raise engine.
scientia non olet · About LEMON Manuals