LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical 5.7L V8) >> Removal & Installation >> Crankshaft Front Oil Seal >> Removal

Crankshaft Front Oil Seal: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Front oil seal can be replaced without removing front cover.
  1. Disconnect negative battery cable. Release accessory drive belt tensioner. Remove drive belt. Release A/C belt tensioner, and remove belt. Raise and support vehicle. Remove starter. Remove right flywheel cover bolt and cover.
  2. Remove transmission cooler lines from radiator (A/T). If more room is needed, remove power steering cooler from plastic support (if equipped). Remove crankshaft balancer. Carefully pry seal from timing cover.
scientia non olet · About LEMON Manuals