LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Analog Instrument Panels) >> Symptom Tests >> TIRE PRESSURE MESSAGE DISPLAYED (NO DTCs)

TIRE PRESSURE MESSAGE DISPLAYED (NO DTCs)

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. If Tire Pressure Monitoring (TPM) diagnostic system check has been performed, go to next step. If TPM diagnostic system check has not been performed, see TIRE PRESSURE MONITORING (TPM) SYSTEM DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM.
  2. Use a manual tire pressure gauge to check tire pressure for each tire. Check recommended tire pressure located on side wall of tire. If tire pressure is okay, go to next step. If tire pressure is not okay, go to step  7 .
  3. Test drive vehicle at speeds greater than 25 MPH (40 km/h) for 5 minutes or until tire pressure data is received. Monitor DIC tire pressure. Tire pressure readings will be 5-42 psi (34-289 kPa). If tire pressure readings are as specified, go to next step. If tire pressure readings are not as specified, go to step  5 .
  4. If HIGH TIRE PRESSURE, LOW TIRE PRESSURE or FLAT TIRE message is displayed on DIC, go to next step. If no messages are displayed, system is okay at this time.
  5. Connect scan tool to DLC located under steering column. Select RFA DATA DISPLAY. Test drive vehicle at speeds greater than 25 MPH (40 km/h) for 5 minutes or until tire pressure data is received. Observe tire pressure data. Scan tool will display tire pressure as 148 psi (1020 kPa) until tire pressure data is received. After tire pressure data is received, tire pressure readings will be 5-42 psi (34-289 kPa). If tire pressure readings are as specified, go to INSTRUMENT PANEL CLUSTER (IPC) DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM. If tire pressure readings are not as specified, go to next step.
  6. Replace suspect Tire Pressure Monitoring (TPM) sensor. Tire must be dismounted from rim to replace TPM. After replacement, reprogram all TPM sensors. See TIRE PRESSURE MONITOR (TPM) SENSOR PROGRAMMING  under PROGRAMMING. After repairs, go to step  8 .
  7. Adjust air pressure in tire as necessary. After resetting air pressures, use RESET button on DIC to reset Tire Pressure Monitoring (TPM) warning messages. Go to step  3 .
  8. Perform TIRE PRESSURE MONITORING (TPM) SYSTEM DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM.
scientia non olet · About LEMON Manuals