LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Camaro Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Analog Instrument Panels) >> Symptom Tests >> High Beam Indicator Inoperative

High Beam Indicator Inoperative

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform INDICATOR SYSTEM CHECK  under SYSTEM TESTS. Go to next step.
  2. Turn high beams on. If high beams come on, go to next step. If high beams do not come on, locate and repair problem in headlight system. See HEADLIGHT SYSTEMS & DAYTIME RUNNING LIGHTS article.
  3. Disconnect instrument cluster connector. Connect test light between instrument cluster connector terminal A2 (Light Green wire) and ground. See WIRING DIAGRAMS  . Turn high beams on. If test light comes on, go to next step. If test light does not come on, go to step  7 .
  4. Check high beam indicator bulb. If bulb is faulty, go to step  6 . If bulb is okay, go to next step.
  5. Replace IPC. See INSTRUMENT PANEL CLUSTER (IPC)  under REMOVAL & INSTALLATION. After repairs, go to step  8 .
  6. Replace bulb. See INSTRUMENT PANEL CLUSTER (IPC) BULBS  under REMOVAL & INSTALLATION. After repairs, go to step  8 .
  7. Repair open or high resistance in Light Green wire. See HEADLIGHT SYSTEMS & DAYTIME RUNNING LIGHTS article. After repairs, go to next step.
  8. Turn ignition off and reconnect all disconnected components and connectors. Turn ignition on. Go to INSTRUMENT PANEL CLUSTER (IPC) DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM.
scientia non olet · About LEMON Manuals